|Name:||Double Layer Forming Machine||Weight:||11.5T|
|Warranty:||12 Months||Voltage:||380v/50 Hz|
|Use:||Roof,Wall,warehouses||Control System:||Siemens PLC Control With Touch Screen|
|Color:||As Customers Requirement,BLUE AND YELLOW||Roller Material:||45# Steel|
11.5T Double Layer Roofing Sheet,
Double Layer Roofing Sheet 50Hz,
double PLC Roof Sheet Forming Machine
1250mm 380V PLC Roof Panel Roll Forming Machine With Hydraulic Cutting
1. Brief introduction of Double Layer Forming Machine
Double layer forming machines for roofing and cladding sheets , with the greatest advantage is one double layer machine can make two design sheets.
usually, one layer forming machine or single layer forming machine only make one roofing design.
Therefore, if customer has limited install space and required to make two roofing designs, double deck machine is best choose.
shall we introduce you difference between one layer machine and double layer machine?
one layer machine include 5 ton manual decoiler, forming machine with post cut, hydraulic station, plc controller run out table.
double layer machine have additional set rollers and cut blade for another roofing design. that is , two sets rollers share with one machine base, motor , hydraulic station, plc controller and cut frame.
therefore, double layer forming machine only work one layer at one time.
Recently, double layer machine cut controlled by motor is adopted, it is good use in hot area, because, traditionally, hydraulic station give power to cut action, if in hot area, the oil in hydraulic station will very hot.
while motor control cut in hot area is good idea.
2. Specifications of Double Layer Forming Machine
|Technical Parameters (some depend on the final design)|
|1||Style||glazed roof tile double layer roof sheet roll forming machine|
|4||Forming steps||Up layer :11rows Down layer :13rows|
|5||Forming speed||Glazed design :1.5-3.0m/min Wave design:10-15m/min|
|6||Hydraulic station power(Kw)||4kw|
|7||Diameter of shaft||70mm|
|8||Hydraulic pressure||18-20 MPa|
|9||Electric condition(Voltage )||380V/3Phase/ 50HZ (or based on customer's need ,for example :220V 440V 415V or 2Phase 60HZ )|
|10||Suitable to process||Color steel plate(G330 or G350 ) galvanized steel coil|
|11||Manual uncoiler max capacity||5000kgs|
|13||Raw material thickness||0.3-0.8mm|
|14||Effective width||800mm and 836mm|
|15||Material width||1000mm and 1000mm|
|17||Material of the cutting blade||Cr 12 quenched treatment 58℃-62℃|
Main Shaft Material
|45# steel with finish turning|
|19||Roller materials||45# Forging Steel with Chromium Plate|
|20||Machine Under Frame||400 H beams and side wall 25 mm|
4. details photos of Double Layer Forming Machine
Contact Person: Linda